SSR-16 (98) (CONTEC)

Solid-state relay 16-point parallel output module.On board
There is one 8-deep dip switch.

Output points 16 points (4 contacts 1 common x 4 group)
Number of occupied I / O ports 8-bit 2-port or 16-bit 1-port
Consumption current 5V DC, 550mA (Max)
Operating conditions 0 to 50 ° C, 20 to 90% (without condensation)

Output type SSR 1 make contact
Use SSR SR-S1A2002PC (made by Nippon Switchgear)
Rated load voltage AC100 / 200V rms
Rated load current AC1A rms
Peak repeat off voltage 600V
Operating load voltage range 24 to 250 V rms
Open circuit leakage current 3mA rms (Max)
Contact voltage drop 1.5V rms (Max)
Response speed 1/2 cycle + 1 ms

・ 8-station dip switches SW1 and SW2: I / O port address setting
See PIO-48W (98).

Relationship between port address and output data
The following is the order of setting port address: D7 D6 D5 D4 D3 D2 D1 D0
+ 0 • O07 O06 O05 O04 O03 O02 O01 O00
+1 O15 O14 O13 O12 O11 O10 O09 O08

Connector pin assignment
Connector used: PCB side KEL 7011-020-161R, terminal side KEL 7011-020-160
Top row from the right B10, B9, B8 ..... B3, B2, B1 and bottom row from the right
A10, A9, when viewed with the A8 ····· A3, A2, A1, pin assignment is as below.
The following is the order of the terminal number, signal name, and explanation:

A1 O00 + 0 port output (lower) B1 O 08 +1 port output (lower) 
A2 O01 + 0 port output (lower) B2 O09 +1 port output (lower) 
A3 O02 + 0 port output (lower) B3 O 10 +1 port output (lower) 
A4 O03 + 0 port output (lower) B4 O 11 +1 port output (lower) 
A5 COM1 + 0 port lower common B5 COM 3 +1 port lower common 
A6 O04 + 0 port output (upper) B6 O12 +1 port output (upper) 
A7 O05 +0 port output (upper) B7 O13 +1 port output (upper) 
A8 O06 + 0 port output (upper) B8 O 14 +1 port output (upper) 
A9 O07 +0 port output (upper) B9 O15 +1 port output (upper) 
A10 COM2 +0 port upper common B10 COM4 +1 port upper common
The commons (COM 1 to 4) on the board are independent of each other in the board.

About the LED on the board
Below, SSR contacts ■ LED status ■ Internal signal logic order:
Make contact ■ lighting ■ 1
Break contact ■ Off ■ 0